9
EATON Hydraulics
Series 10 VersaSteer Parts and Repair October 2004
Disassembly
19. Carefully Remove Seal with
a thin-blade screw driver.
Do not scratch seal groove
with screw driver.
20. Use thin bladed screw
driver to pry dust seal
from housing. Do not
damage housing.
Ball
Race
Bearing
Race
Ball
Roll Pin
Roll Pin
O-ring
Seal
Dust Seal
*
Anti-Cavitation Valves
for Cylinder Ports
Reference Page 4
for other configurations
Manual Steering
Check Valve
Figure 6
18. Do not remove any
valves other than
manual steering check
valve assembly and
anti-cavitation valve
assembly. All other
valves are factory preset
and are non-serviceable.
21. Push pin from spool and
sleeve assembly.
22. Remove Drive
23. Push spool partially from
control end of sleeve,
then carefully remove
centering springs and
retaining ring from spool
by hand (figure 7).
*Note
Standard input torque unit
uses six centering springs
and two spacers.
Medium input torque unit
uses four centering
springs and three spacers.
Low input torque unit
uses four centering
springs and two spacers.
Standard Input Torque
Spring/Spacer Package
Low Input Torque
Spring/Spacer Package
Medium Input Torque
Spring/Spacer Package
Figure 7
