8.
Align plunger with
sleeve (figure 16).
9.
Push plunger into sleeve
until it bottoms out,
rotate 1/4 turn
(figure 17).
10. While holding sleeve in
housing, withdraw
plunger.
11. Withdraw sleeve.
12
EATON Hydraulics
Series 10 VersaSteer Parts and Repair October 2004
7.
Push seal onto plunger.
Lip of seal should be
between o-ring and
plunger. No gap should
exist between o-ring
and seal (figure 15).
Figure 15
Figure 16
Figure 17
Figure 18
Assembly
2-Piece Shaft Seal
Installation
6.
Align seal with plunger.
cross section "L" shape
of seal should be upside
down (figure 14).
Figure 14
25mm[1in]
Bearing Race
Needle Thrust Bearing
Figure 19
Figure 20
13. Clamp housing in vice
(figure 19).
14. Install two bearing races
and thrust bearing as
shown in figure 20.
12. Inspect seal
installation. Seal
and o-ring must
both be within
shaft seal counter
bore of housing
(figure 18).