110, 230, and 450 Series Steering Control Units
3
Tools required for disassembly and reassembly.
— Screwdriver (102-152 mm [4 in. - 6 in.] long, x 3 mm [118 in.]
wide flat blade).
— 6 Point (E10) Drive part No. 64489-000* or 1/2 inch socket for
current hex head cap screws.
— Breaker bar wrench.
— Torque wrench (30 Nm [275 lb-in] capacity).
— Plastic hammer or rubber hammer.
— 1/4 inch Hex key.
— #10-24 machine screw, 38 mm [1-1/2 in.] long.
— Needle nose pliers.
The following tool is not necessary for disassembly and reassembly,
but is extremely helpful.
Spring installation tool 600057
*
*
Tools available—by special order—through our service department.
