1. From the top of the box cover, insert the M22 button into the
box cover.
2. From the bottom of the cover, tighten the nut onto M22 but-
ton.
3. From the bottom of the cover, snap the shroud (if supplied)
cut to the appropriate length for the reset rod into the M22
button.
4. If the reset paddle is not already assembled to the required
reset rod (see Reset Rod Kit table), assemble as shown by
inserting reset rod into reset paddle.
5. From the bottom of the cover, snap the required reset rod
into M22 button. The flat side of the paddle should face
away from the box cover’s rectangular opening with the
“Up” arrow facing toward the top of the box.
Reset Rod Installation
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A
A
B
B
C
C
D
D
EATON CORPORATION - CONFIDENTIAL AND PROPRIETARY
NOTICE TO PERSONS RECEIVING THIS DOCUMENT AND/OR TECHNICAL INFORMATION
THIS DOCUMENT, INCLUDING THE DRAWING AND INFORMATION CONTAINED THEREON, IS CONFIDENTIAL AND IS THE
EXCLUSIVE PROPERTY OF EATON CORPORATION, AND IS MERELY ON LOAN AND SUBJECT TO RECALL BY EATON AT ANY TIME.
BY TAKING POSSESSION OF THIS DOCUMENT, THE RECIPIENT ACKNOWLEDGES AND AGREES THAT THIS DOCUMENT CANNOT
BE USED IN ANY MANNER ADVERSE TO THE INTERESTS OF EATON AND THAT NO PORTION OF THIS DOCUMENT MAY BE
COPIED OR OTHERWISE REPRODUCED WITHOUT THE PRIOR WRITTEN CONSENT OF EATON. IN THE CASE OF CONFLICTING
CONTRACTUAL PROVISIONS, THIS NOTICE SHALL GOVERN THE STATUS OF THIS DOCUMENT.
C Eaton Corporation, All Rights Reserved
TITLE
DRAWING
NUMBER
SIZE
D
CHANGE RESPONSIBILITY
REVISION
CLASS CODE
SHEET
SCALE
OF
1
1
DATE (YYYY/MM/DD)
DRAFTER/DESIGNER
MANUFACTURING
REVISION DESCRIPTION
DIMENSIONS IN
UNLESS OTHERWISE SPECIFIED
DRAWING IN ACCORDANCE WITH
ASME Y14.5M-1994
ENG/MFG REFERENCE
X.XX+/-XX
ST
SYMBOLS PER
468-1143
J. UPHAUS
ENGINEERING APPROVED
ECO#
INCHES
X.X
X.XX
X.XXX
X°
X.X°
±
0.1
±
0.02
±
0.005
±
1°
±
.5°
NA
N/A
2015/03/18
J. UPHAUS
N/A
N/A
N/A
N/A
P52899 RESET ASSEMBLY VIEW
N/A
NTS
2015
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton .com
© 2014 Eaton
All Rights Reserved
Publication No . P52899 / 002
May 2015
Eaton is a registered trademark .
All other trademarks are property
of their respective owners .
Box 1 Non-Combination Enclosed Control
and C600M Cover Control Kit Wiring
Instructions and Operation
P52899
Effective May 2015
