Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
109
C
Chhaapptteerr 66 C
Coom
mm
muunniiccaattiioonn
66..11
C
Coom
mm
muunniiccaattiioonn
This chapter describes the:
•
DB-9 communication port
•
X-Slot cards
•
Relay output contacts
•
Programmable signal inputs
•
Remote emergency power-off (REPO)
•
Parallel communication
shows the location of the communication options and control terminals on the UPS.
Figure 74. Communication Options and Control Terminals (Standalone UPS shown)
DB-9 Communication Port
REPO (normally-closed)
REPO (normally-open)
Signal Input 2
Signal Input 1
X-Slot Communication Bay 2
X-Slot Communication Bay 1
Relay Output Contacts
Standalone/Parallel
Redundant Signal Wiring
(For Parallel Use Only)
66..22
IInnssttaalllliinngg C
Coom
mm
muunniiccaattiioonn O
Oppttiioonnss aanndd C
Coonnttrrooll TTeerrm
miinnaallss
To install the communication options and control terminals:
1.
Install the appropriate X-Slot card and/or necessary cable(s) ( See
and
.
Summary of Contents for BladeUPS none
