EATON HEVC 5005
Installation, Operation and Maintenance Manual E-CLCL-CC002-E2
May 2017
10
HEVC 5005
2.6.5
Attach the axial locking device (if required) to the
flange of the remaining drum with the appropriate
short screws and lockwashers. There are tapped
holes in the drum to accept the screws.
2.6.6
Hoist the element/drum (axial locking device) into
position, align the tapped holes in the drum having
the male pilot with the tapped holes in the drum
attached to the drum hub, and attach both drums
to the drum hub with the appropriate fasteners.
See Table 1. Make sure the male pilot fully engages
the female register. If an axial locking device is used,
take special care when hoisting the element
between the shafts. The axial locking device
mounting plate binds easily against the spider face.
2.6.7
Align the air connections and reassemble the
element halves, making sure the spacers are in
place between the elements. See Figure 7.
2.6.8
Reassemble the air connection tubes. If an elbow
has been removed, use a good quality pipe sealant
on the threads. See Figure 7.
Note: The elbow assemblies on the outboard element (farthest
from the spider) use rubber compression sleeves. Make sure the
sleeves are secure on the long air tubes.
2.6.9
Install the air connection gaskets onto the air tubes.
The metal backup washer is to be positioned toward
the elbow (away from the spider). See Figure 6.
2.6.10 Align the element air connections with the
corresponding passages in the spider and attach
the element to the spider with the appropriate
fasteners. See Table 1. Make sure the element
fully engages the register in the spider.
2.6.11 Attach the axial locking device mounting plate
(if required) to the spider with the appropriate screws
and lockwashers. Rotate the motor shaft and push
the spider toward the mill until the axial locking
device mounting plate is flush against the spider
face. Tighten the screws.
Caution
Do not attempt to pull the motor shaft back onto
magnetic center by tightening the axial locking
device mounting screws. To do so will damage
the axial locking device.
Steel washer
Rubber backing
Figure 6
Figure 7
Spacers
Long air tube
Short air tube
Short air tube
Rubber sleeve
