Eaton 93E 30IAC-D, Installation And Operation Manual

Page: 45 / 76

Installation
Eaton 93E Integrated Accessory Cabinet-Distribution (30IAC-D and 60IAC-D) Installation and Operation Manual P-164000072—Rev 2 www.eaton.com/powerquality 4-11
4.3 Installing the Power Terminal Cover Base
To install the power terminal cover base:
1. Locate the terminal cover base (see Figure 4-8) from the parts kit.
2. If installing wiring using conduit, continue to Step 3; otherwise, skip to Step 4.
3. Punch or drill holes in the bottom of the power terminal cover base (see Figure 4-8 and Figure 4-9) for the
AC input conduit.
4. Using the hardware provided, install the terminal cover base to the back panel of the IAC-D using the
existing cabinet screw holes (see Figure 4-9).
5. Continue to paragraph 4.4 on page 4-13.
Figure 4-8. IAC-D Power Terminal Cover Parts
NOTE Wiring can be installed using conduit between cabinets or by routing wiring through
the power terminal cover base wiring channels.
Top
Left Side
Conduit Landing for AC
Input when using conduit
(Install conduit to bottom
of base.)
Right Side
Base
Wire Hooks
Base (inside view)
NOTE Do not install the Power Terminal Cover Left and/or Right Side covers if wiring adjacent cabinets using the
power terminal base wiring channel.