614-40099-00
18
Operation status
Possible cause
Action
In AVR mode
No beep
The UPS is operating normally but the
utility voltage is outside normal mode
thresholds.
The UPS is powering the equipment through the
Automatic Voltage Regulation device. The equipment is
still normally protected.
On Battery
One beep every 10
seconds
A utility failure has occurred and the
UPS is in Battery mode.
The UPS is powering the equipment with battery
power. Prepare your equipment for shutdown.
End of backup time
1 beep every 3
seconds
The UPS is in battery mode and the
battery is running low.
This warning is approximate, and the actual time to
shutdown may vary significantly. Depending on the
UPS Load, the "Battery Low" warning may occur before
the battery reaches 20% capacity remaining.
4.3 Display functions
Press the Enter (
⮠
) button to activate the menu options. Use the two middle buttons (
⯅
and
⯆
) to scroll through the
menu structure. Press the Enter (
⮠
) button to select an option. Press the (
ESC
) button to cancel or return to the previous
menu.
Menu map for Display Functions.
Main menu
Submenu
Display information or Menu function
Measurements
-
Load: [Total Load/Load (Primary)/Load (Group 1)/Load (Group 2)] : W, A, VA, pF
[Input/Output] : V, f
[Battery Info] : %, min, V, number of EBM, Age service, Age Warning
[Average power usage] : Toal, Primary, Group 1, Group 2
[Cumulative power] : Total, Since Primary, Since Group 1, Since Group 2
Control
Load Segments
Group 1: ON / OFF
Group 2: ON / OFF
These commands overrule user settings for load segments.
Start battery test
Starts a manual battery test (possible if load >20% and battery >80%)
Change battery
Disable charger, Replace battery, Update settings
Connectivity test
Dry contacts test, Relay card test, Line failure test, Battery low test
Functions reset
Reset fault state, Reset power usage, Reset battery life, Card reset, Restore
factory set
Settings
Local settings
Sets product general parameters, See users settings
