Page 15
614-07977-00_EN
ENGLISH
3. Installation
HotSwap MBP module operation
54
55
53
UPS start-up with the HotSwap MBP module
1.
Check that the UPS is correctly connected to the
HotSwap MBP
module.
2.
Set switch
(55)
to Normal position.
3.
Start the UPS by pressing the ON/OFF button on the UPS control panel.
The load is supplied by the UPS.
LED
(53)
"UPS ON - OK to switch" on the
HotSwap MBP
module goes ON.
HotSwap MBP module test
1.
Set switch
(55)
to Bypass position and check that the load is still supplied.
2.
Set switch
(55)
back to Normal position.
The HotSwap MBP module has a rotary
switch
(55)
with two positions:
Normal
the load is supplied by the UPS,
LED
(53)
is on.
Bypass
the load is supplied directly by
the AC-power source. LED
(54)
is on.
3.7 UPS connection without a FlexPDU or HotSwap MBP module
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power
source and the true electrical consumption of the total load.
10
32
35
9
7
31
8
1.
5PX 1500i / 2000i
: connect the
UPS input socket
(10)
to the
AC-power source using the cable
of the protected equipment.
5PX 2200i / 3000i
: connect the
supplied cable
(31)
(250 V -
16 A) to the socket
(10)
, then
to the AC-power source.
2.
Connect the loads to the UPS
using the cables
(32)
.
It is preferable to connect the
priority loads to the four outlets
marked
(9)
and the non-priority
loads to the four outlets marked
(8)
that can be programmed in
pairs (1 and 2).
For the
5PX 2200i / 3000i
models,
connect any high-power devices
to the 16 A outlet
(7)
.
To program shutdown of outlets
(8)
during operation on battery
power and thus optimise
the available backup time,
please check the in/out settings.
3.
Fit the connection securing system
(35)
that prevents the plugs from
being pulled out accidentally.
Note.
The UPS charges the battery as soon as it is connected to the AC-power source, even if
button
is not pressed.
Once the UPS is connected to the AC-power source, eight hours of charging are required before the
battery can supply the rated backup time.
