4
200 A 15/25 kV class elbow installation instructions
InstallatIon InstructIons
MN650042EN February 2017
Elbow and probe contact installation
Step 5
Clean the exposed conductor using a wire brush.
Place the coppertop (bimetal) connector on the conductor.
Make sure threaded hole in connector faces the
apparatus bushing.
Crimp the connector in place using a tool and die
combination listed in Table 1. Start crimping just below the
knurled line and rotate each successive crimp to prevent
bowing. Do not overlap crimps. Place as many crimps on
the connector as will fit.
Step 6
Clean excess inhibitor grease from coppertop connector by
wiping toward threaded eye.
Clean insulation with a lint free cloth saturated with a
cleaning solution. Wipe insulation toward insulation shield.
Apply a thin coating of grease to the insulation.
Clean and lubricate the cable entrance of the elbow.
Place elbow on cable. With a twisting motion, push elbow
onto cable until threaded eye of coppertop connector is
visible in the elbow interface.
Step 7
Use the provided hex-probe installation tool to install probe
contact into the compression connector. Take care not to
cross-thread probe.
Proper torque is applied when the tool achieves a 180° bend.
otee:
N
If a different installation tool is used it must apply a
torque of 60-80 in-lbs to achieve proper installation.
Attach a ground lead to the grounding eye of the elbow.
Step 8
Clean the elbow and bushing interface and apply a thin
uniform layer of silicone lubricant to both interfaces. Push
the elbow onto the bushing until it is fully seated.
Hook the legs of the bail assembly into the tabs of the bushing
clamp. Thread the eyebolt of the bail assembly tight against the
back of the pulling eye of the elbow. (See Figure 2.)
Table 1 . Crimp chart
Connector
5/8" Diameter
3/4" Diameter
Conductor size
No. 4 Thru 2/0 stranded
3/0 - 4/0 Stranded
Burndy
®
TOOL
Y34
Y35 OR Y39
MD6
Y34
Y35 OR Y39
MD6
DIE
A243
U243
UBG
W243
WBG
U247
U247
U467
W247
A25AR
U25ART
U687
BG
NOSE
W687
A27AR
U27ART
Thomas & betts
®
TOOL
UT-3
UT-5
UT-15
UT-5
UT-15
DIE
5/8"
TV
54 H
TV
66
Kearney
TOOL
O
WH1, WH2 or WH3
O
WH1, WH2 or WH3
DIE
5/8"
NOSE
9/16"
9/16"
737
747
737
747
ACA Conductor
Accessories (ALCOA)
TOOL
12A
12A
DIE
B24 EA
B39 EA
Anderson
®
Tool
VC-5, VC-6
VC-5, VC-6
Edison Electric Institute – Reference
8A
10A