ICUS CONDENSING UNIT INSTALLATION MANUAL
Jan 09:F\Qualitair Eng\Icu\Manuals\0412118S
3. LOCATION & MOUNTING OF OUTDOOR UNIT (ICUS)
3.1
Location
The unit can either be mounted on a level surface or suspended from a vertical wall using the wall
mounting Optional kit (1) . The unit should always be mounted on a load bearing wall and not a
partition wall. Ensure there is sufficient free area around the unit as detailed in Figure 3.2.
3.2
Fixing
Two-off hole fixings (2) and two-off slot fixings (3) suitable for M10 fixings are provided in the base of
the unit to secure the unit to a suitable plinth, or to the wall mount bracket kit. If required, the
contractor should install the unit on anti-vibration pads.
3.3
Service Connections
The refrigerant pipe (4) and electrical connections (5) are located at the right hand end of the unit.
3.4
Air Entry
Ensure there is adequate air entry at the back of the unit as detailed in Figure 3.2 above.
SPECIAL NOTE
ENSURE CONDENSER HAS ADEQUATE CLEARANCE AROUND IT AND IS NOT AFFECTED BY
NEIGHBOURING CONDENSING UNITS AND OTHER OBSTRUCTIONS.
Figure 3.3 – ICUS Wall Bracket
Fixing
Figure 3.1 ICUS Unit Positioning
Figure 3.2 ICUS Unit Fixing
ICUS30
ICUS40
ICUS55
ICUS80
Dim ‘y’mm
240
240
310
310
Dim ‘z’mm
570
570
620
620
