EAT C-Sharp, Instructions For Use Manual

Page: 6 / 19

6
SETUP
1. Transport screws
For the safe transport of the turntable with unique design where the motor and the tonearm
are mounted on a different part of floating chassis are used the transport screws (15) .
Remove three transport screw from the carbon part of the chassis before installing the sub-
platter (14) , the drive belt (13) and the platter (2) .
2. Protective covers, sub-platter and drive belt instalation
Main bearing shaft (18) and housing in the sub-platter (14) are covered by special plastic
protective covers. These covers serve as protection against dust and dirt and keeps the
bearing shaft and housing sufficiently lubricated. If necessary, lubricate the shaft with grease
from tha attached accessories. Maximum dose for greasing is
0,5ml
. Deduct the quantity
from the scale on supplied syringe with grease.
Remove the protective covers from the main bearing shaft (18) and from the sub-platter
(14) . Install the sub-platter and the drive belt as mentioned on the next pictures.