Troubleshooting
The platter doesn’t turn although the unit is switched on:
•
The unit is not connected to the mains power supply (the building’s electrical system).
•
No mains power is being delivered at the socket.
•
The drive belt is not fitted properly or has slipped off.
No signal through one or both channels:
•
•
Phono input not selected at amplifier
.
•
Amplifier not switched on
.
•
Amplifier or speakers are defective or muted.
•
No connection to the loudspeakers.
Strong hum on phono input:
•
No ground connection from cartridge or arm or arm cable to amplifier, or ground loop.
Distorted or inconsistent sound from one or both channels:
•
Possible Causes:
Turntable is connected to wrong input of amplifier,
MM/MC switch is
incorrectly set
, n
eedle or cantilever damaged
,
Wrong
RPM
,
drive belt overstretched or
dirty; platter
bearing needs lubrication or is dirty or damaged.
Service
:
Should you encounter a problem that you are not able to identify or alleviate
despite the above information, please contact your dealer for further advice. Only when
the problem cannot be resolved should the unit be sent to the responsible distributor in
your country. Please keep the original packaging, as repairs will only be performed if the
unit is returned in its appropriate packaging.
Never return a turntable without making sure that is it properly disassembled and correctly
packaged in the original packaging according to the supplied diagram. Please
r
emove the
feet, counterweight, platter, cartridge and belt and pack them separately. Fit the cartridge
protection cap. Insert the transport lock for the tonearm prior to carefully packaging the
turntable.
Warranty
:
See enclosed warranty from your local distributor.
The manufacturer
accepts no responsibility for damage caused by failing to adhere to these instructions for
use and/or by transportation without the original packaging. Modification
or change to any
part of the product by unauthorized persons releases the manufacturer from any liability
over and above the lawful rights of the customer.
The information above was correct at the time of going to press. The manufacturer reserves the right to
make changes to the technical specifications without prior notice
or obligation to modify existing units,
as
deemed necessary to uphold the ongoing process of technical development.
E.A.T. European Audio Team is a Registered Trademark of Jozefina Lichtenegger.
The contents of the USA version of this manual are Copyright © 6/2016. VANA. Ltd based on original
copyright material from EAT.
No signal contact from the cartridge to the internal tonearm wiring; or from that to the
arm
arm
lead; or from that to the phono box; or between that and the amplifier. This could be
due to a faulty plug, broken wire or loose solder joint in the plug/socket connection.
1
6