Q11: Can the model continue printing if electricity is cut off?
A: If there is no electricity in the process of printing, the models cannot continue printing
.
Q12: Can pause printing in the process of printing?
A: Yes, shortly press the printing button, it will pause. Then shortly press again, it will continue
printing.
Q13: How to stop printing?
A: Please press the printing button for 3 seconds then release, then it will stop printing (precaution:
cannot continue printing after stop).
Q14: Filament will run out soon in the process of printing, What should to do?
A: Please pause the printing, then slide the switch to retract gear, use hand to pull up the filament.
Precaution: please do this before all the filament goes into the feeding hole or there will be no
filament hand can pull up).Then put new filament into the hole and use another hand to slide the
switch to feed gear, wait about 10 seconds till the filament come down. Then slide switch to the
middle gear and press printing button shortly to resume printing. Please pay special attention
that ,after feeding 10 seconds, timely slide switch to the middle gear in avoid that the filament
pimple appear in the model.
Q15: When print the first layer there is no filament on the bed, why?
A: Please check if the distance between nozzle and bed is to close leads no space for filament to
come out.
Q16: What’s the meaning of light in the printing button?
A: The printer has only 1 light color, that is Green.
(1), When the switch is slide to feed or retract gear, it will flash at very FAST rate.
(2), When it is in normal printing, it will flash at STEADY rate (flash every 3 seconds).
(3), When pause printing, the light will become normal light without flashing.
Q17: Can the machine print online?
A: Yes, it needs to use third party slicing software CURA. Please refer to the above step of point 5.0
Online printing(For experts)
Q18: How can I adjust the machine to Zero?
Summary of Contents for NANO
Page 1: ...USER S MANUAL ...
