Q13:How to stop printing?
A:Please press the printing button for 3 seconds then release,then it will stop
printing(precaution:can not continue printing after stop).
Q14:Filament will run out soon in the process of printing, What should to do?
A:Please pause the printing, then slide the switch to retract gear, use hand to pull up the
filament.(precaution:please do this before all the filament goes into the feeding hole,or there will be
no filament hand can pull up).Then put new filament into the hole and use another hand to slide
the switch to feed gear, wait about 10 seconds till the filament come down.Then slide switch to the
middle gear and press printing button shortly to resume printing.Please pay special attention
that ,after feeding 10 seconds, timely slide switch to the middle gear in avoid that the the filament
pimple appear in the model.
Q15:When print the first layer,there is no filament on the bed ,why?
A:Please check if the distance between nozzle and bed is to close cause no space for filament to
come out.
Q16:Can the_machine print online?
A:Yes, it needs to use third party slicing software CURA. Please refer to the above step of point
5.0 Online printing(For experts)
Thanks for choosing Easythreed, we will try our best to serve you
ShenZhen Easythreed Technology CO.,LTD
Address : No.A2 , 2nd Floor , Avant Low Carbon Innovation Park , No1034 of
Longgang Road , Pingdi Street , Longgang District , ShenZhen , China
Website :
www.easythreed.com
Email:
