Safety and Electrical Connections
1.
Never enter water with electrical connections plugged in or in
operation. Even though units are supposed to be connected to GFCI
protection, it is NEVER recommended to enter water with equipment in
operation.
2. Lights must be attached to matching 2 pin cords and 2 pin 12 volt AC
controller as provided.
3. Never connect the lights directly to a 110 volt or higher outlet.
4. Connect the supplied controller/transformer to a 110 volt receptacle that is
protected by a Ground Fault Circuit Interrupter.
5. Do not modify wiring in any way, quick plug ends must stay intact to
function and should not be replaced with any other connections.
6. Not approved for swimming pool or spa use.
7. All electrical work must be performed by a qualified technician. Always follow
the National Electrical Code (NEC) or the Canadian Electrical Code as well as
all local, state and provincial codes. Failure to follow manufacturer’s installation
instructions may result in electrical shock, fire hazard, personal injury or
death, damaged equipment, provide unsatisfactory performance and will void
manufacturer’s warranty.
WFL2 • WFL3
Thank you for purchasing the AquaShine™ warm white LED fountain light kit.
This kit will transform your fountain into a beautiful night time display. These low
voltage lights use only 11.5 watts per fixture (maximum with full color mix).
Fountain Light Kit
Fountain Light Kit
Stainless Steel, Warm White LED Light Kits
Stainless Steel, Warm White LED Light Kits
Two-light kits for fountains up to 3/4 hp
Two-light kits for fountains up to 3/4 hp
Three-light kits for fountains up to 2 hp
Three-light kits for fountains up to 2 hp
Compatible with EasyPro Aqua Fountains and AquaFloats
Compatible with EasyPro Aqua Fountains and AquaFloats
and Kasco VFX or JF series fountains with one piece float
and Kasco VFX or JF series fountains with one piece float
Instructions for Operation •
Instructions for Operation • Safety • Warranty
Safety • Warranty
1
