EN
22
6. Allow the battery pack to charge until the control lamp of the charging station goes out
and the one of the mains adapter is constantly lit.
7. First pull the mains adapter out of the plug socket and then pull the barrel connector
out of the charging station.
8. Remove the battery pack from the charging station.
Use
PLEASE NOTE!
■
Ensure prior to each use that the openings of the device are clear. Keep the air outlet
opening clean.
■
Switch the device off for at least 15 minutes after a maximum of 5 minutes of constant
operation, to ensure that it does not overheat.
■
Do not over
fi
ll objects! They could burst. Determine the maximum pressure before
pumping them up.
1. Twist the turning ring (
9
) anticlockwise to loosen it.
2. Plug or twist the adapter (
4
) you want either directly into the air outlet opening (
10
)
or
fi
rst screw it tightly on the compressed air tube (
8
) and then plug or twist this into
the air outlet opening.
3. Twist the turning ring clockwise to secure it.
4. Plug the battery pack (
5
) into the mount on the bottom of the device. It must engage.
5. Remove the protective cap from the valve of the object which is to be in
fl
ated if nec-
essary.
6. Plug the adapter into the valve.
7. Press the on switch (
7
) and keep it pressed down. The device starts to operate.
8. Watch the pressure display (
1
). Once the required pressure has been reached, let go
of the on switch. The device stops.
9. Release the adapter from the valve.
10. Reattach the protective cap on the valve.
11. Pull the adapter or compressed air tube out of the air outlet opening and press it into
its respective holder on the device.
If the performance of the device diminishes, the battery pack needs to be charged.
