TERMINAL BLOCK CONNECTION
Ground
Braid
Power Leads
Heater
Cable
5 TSRP POWER CONNECTION KIT
Installation Instructions
POWER CONNECTION
1. Place gasket on the box adapter.
2. Position the junction box on the box adapter and
secure it with the conduit locknut.
3. Connect bus wires and ground braid from all
heater cables to the terminal block. See diagram
below.
4. Apply silicone at point braid leaves the overjack-
et.
5. Push all wires, cables and the terminal block inside
junction box.
6. Place the box cover and box cover gasket onto
the junction box, and install warning label as re-
quired.
Terminal Block
Ground Wire
Ground Braid
Power Termination
Conduit and Drain not included in kit.
(Must be positioned lower than junction box.)
