PRODUCT SUPPORT
|
helpline:
01405 869333
|
email:
Connect the tube (F) to the
nozzle under the upper barrel
(D). Then feed through the
small hole in the lower board
(E). Attach barrels together
by matching up the slots and
twist clockwise.
Attach the tube (F) to the
nozzle on the pump (H). Then
place pump into the lower
barrel (G). Be sure to route the
power cord of pump through
the notch on the lower board.
Fit the groove on the lower
board (E) onto the edge of the
lower barrel (H) and attach
the two pieces.
Connect the long water tube
(B) to the nozzle inside the
pitcher pump (A). Then feed
the tube through the hole of
the upper board (C). Attach
pitcher pump onto the upper
board by matching up the
slots and twist clockwise to
lock into place.
Fit the groove on the upper
board (C) onto the edge of the
upper barrel (D) to attach the
two pieces. Then, connect the
tube (B) to the outlet nozzle
on the upper barrel.
Fill with enough water to
ensure the pump (G) is fully
submerged. Then, connect the
plug to your mains outlet.
PRODUCT SUPPORT
|
helpline:
01405 869333
|
email:
ASSEMBLY INSTRUCTIONS
1
2
3
4
5
PUMP FLOW
Always isolate the electrical mains supply before
touching or adjusting the pump. The pump flow
can be adjusted with the regulator, this is found
on the inlet of the pump. We recommend starting
with the flow regulator fully open and then
adjusting down if required.
Turn...
Clockwise
for
full flow
Anti-clock-
wise
for
reduced flow
6
HB643837_Whiskey Barrels_IM.indd 4
HB643837_Whiskey Barrels_IM.indd 4
14/11/2022 12:21
14/11/2022 12:21
