The EHE010 is intended for use in the electromagnetic environment specified below.
The customer or the user of the EHE010 should assure that it is used in such an environment.
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Group 1
The EHE010 use RF energy only for its internal
function. Therefore, its RF emissions are very low
andare not likely to cause any interference in
nearby electronic equipment.
Class B
The EHE010 is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Not applicable
(internal battery
powered)
Not applicable
(internal battery
powered)
EMISSION TEST
Guidance and manufacture’s declaration – electromagnetic emission
COMPLIANCE
ELECTROMAGNETIC ENVIRONMENT -
GUIDANCE
Electrical fast
transient/burst
IEC 61000-4-4
±2 kV for power
supply lines
±1 kV for input/
output lines
Not applicable
(internal battery
powered)
Not applicable
(internal battery
powered)
Not applicable
(internal battery
powered)
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment.
Surge
IEC 61000-4-5
± 1 kV line(s)
to line(s)
± 2 kV line(s)
to earth
Voltage dips, short
interruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11
<5% UT (>95% dip
in UT) for 0.5 cycle
40% UT (60% dip
in UT) for 5 cycles
70% UT (30% dip
in UT) for 25 cycles
<5% UT (>95% dip
in UT) for 5 sec
Mains power quality should be that of a
typical commercial or hospital
environment. If the user of the EHE010
requires continued operation during
power mains interruptions, it is
recommended that the EHE010 be
powered from an uninterruptible power
supply or a battery.
Power frequency
(50Hz/60Hz)
magnetic field
IEC 61000-4-8
3 A/m
3 A/m
Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical commercial
or hospital environment.
NOTE: UT is the a.c. mains voltage prior to application of the test level.
Electrostatic
discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±6 kV contact
±8 kV air
Floors should be wood, concrete or
ceramic tile. If floor is covered with
synthetic material, the relative humidity
should be at least 30%.
IMMUNITY
TEST
IEC 60601
TEST LEVEL
COMPLIANCE
LEVEL
ELECTROMAGNETIC
ENVIRONMENT - GUIDANCE
The EHE010 is intended for use in the electromagnetic environment specified below.
The customer or the user of the EHE010 should assure that it is used in such an environment.
Guidance and manufacturer’s declaration – electromagnetic immunity
14
15
