16
RECHARGEABLE ROBOT VACUUM
using tools!
1. To remove it, please insert your finger into the groove of the cover plate,
press the buckle, open the cover plate and take out the soft brush.
2. To install it, please put both ends of the soft rubber brush into the
corresponding gap, and then cover the plate.
Caution: Check if the soft rubber brush is blocked by hair or other objects and
clean it regularly, otherwise it will affect the function of the robot.
Clean and Replacement Methods of the Duster Cloth
1.Remove the dirty duster cloth directly, then wash it with clean water and dry
off. And it could be used repeatedly.
(Caution: the wet duster cloth cannot be used, or the robot will work
inefficiently).
2.The robot continues to work after replacing the spare dry duster cloth. Make
sure the rear wheels do not be covered or blocked by the cloth while installing.
Function Overview:
Put the robot on the ground, press the power switch to activate the robot,
press the power switch again to stop.
Please install the robot following the instruction before use, or it could not work
functionally.
