4
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
SET-UP
• If Crimping Tool is closed, squeeze handles
together completely to override ratchet
mechanism and release it. Tool will open.
• To remove installed Dies and replace with
opposite size:
- With Tool fully open, push Dies outward
toward nose of Tool
(FIG 1)
. and Dies will
release from Retaining Block Ball Detent.
- Push desired Dies into nose of Tool until
Ball Detent engages
(FIG 1)
.
OPERATION
• Strip end of wire to expose 3/16”-3/8”
[5-9mm]
(FIG 2)
.
• Slip Silicone Connector Wire Seal Insert
over end of stripped wire with offset collar
outward
(FIG 3)
.
• Set Crimp Terminal into Female Die with the
large “U” feature nested into the “U” feature
of the Die
(FIG 4)
.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
In
Out
Out
In
Silicone Connector
Wire Seal Insert
✓
✓
✓
✓
✓
✓
✓
✓
✓
Ribbed Section In
Offset
Collar
Out
✓
✓
