To order parts and supplies: 800.345.1178 >> eastwood.com
5
UNPACKING
Remove all items from the box. Compare with list below to make sure unit is complete.
• Eastwood ARC200i Welder with 80” [2m], 12 Ga. Power Cord.
• Ground Clamp with 10’ [3m] Cable.
• Electrode (stick) Holder with 12.5’ [3.8m] Cable.
• (5) 1/8” E6013 Electrodes
• Instruction Manual.
FIG. A
Power
✓
FIG. B
COMPONENTS & CONTROLS
Power Switch
The Power Switch is located on the upper rear panel
(FIG A)
.
Power Indicator LED
Illuminates green when the unit is plugged in and the Power
Switch is set to the ON position
(FIG B)
.
Thermal Protection LED
Illuminates Amber when the unit has reached the maximum
internal component temperature
(FIG B)
. This occurs when
the Duty Cycle has been exceeded. The Welder will auto-
matically shut off however the fan will continue running to
cool the overheated components. When a safe temperature
has been reached, the protective circuit will automatically
switch the welder output back on.
Amperage Adjustment Knob
The Amperage Adjustment Knob
(FIG B)
allows the output
amperage to be adjusted from 20 to 200 Amps.
“Stick”/TIG Switch
Located at the lower left of the Control Panel
(FIG B)
.
To operate the unit for “Stick” Welding, position the switch
to the right. To use with the optional TIG Torch Kit, position
switch to the left.
Positive ( + ) Connector
Located at the lower right of the Front Panel
(FIG B)
. When
“Stick” welding, the GROUND Clamp Cable is plugged in
here. If using the optional TIG Torch, the GROUND Clamp
Cable is plugged in here.
Negative ( - ) Connector
Located at the lower left front of the Front Panel
(FIG B)
.
When “Stick” welding, the ELECTRODE Cable is plugged
in here. If using the optional TIG Torch Kit, the TIG TORCH
Cable is plugged in here.
✓
Power
LED
Negative
Connector
Positive
Connector
STICK/TIG
Selector
Switch
Thermal
Protection
LED
Amperage
Adjustment
✓
✓
✓
✓
✓
