4
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
SET-UP
• Using a good quality Teflon sealing tape (Not Included), thread the 1/4” MNPT, Male quick
disconnect inlet fitting into the air inlet.
CONNECTION
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
• A minimum 3/8” I.D. air line should be used for optimal performance.
OPERATION
• With air supply disconnected, snap selected socket or accessory over the retaining ball nested
in the square drive.
• Connect air supply, hold tool securely and depress Paddle to begin rotating action.
Speed is regulated by pressure applied to the Paddle.
• To loosen fasteners, rotate knob on the back of the drive head Clockwise toward the “R”.
To tighten fasteners, rotate knob Counter-clockwise toward the “F”.
INJURY HAZARD!
To avoid injury, always disconnect air supply to Wrench when attaching or
removing sockets or accessories.
To avoid injury, only use sockets and accessories rated for “Impact” use.
