10
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
Inspect rim and tire before mounting for previous damage or bent conditions. Attempting to spin a damaged rim and or tire can
result in serious injury and severe Balancer damage.
Wheels and tires MUST be clean and free of all mud, grit or other debris as they will cause an inaccurate balance reading.
All tire pressures MUST be set to specific vehicle or tire manufactures specifications or inaccurate balance readings will result.
Do not slide wheel/tire over the Main Drive Spindle when mounting or dis-mounting to avoid damage to Main Drive Spindle.
MOUNTING WHEELS ON BALANCER
BALANCER SAFETY FEATURES
Should a malfunction occur during the operation of the Balancer, Depressing the “STOP” Key will stop wheel rotation immediately.
If the Guard is in the up position and the “START” Key is pressed, the Spin Cycle will not begin and “Err-5” will appear in the display.
NOTE: This function can be changed as outlined in the “Settings” section of these instructions.
While in operation, if the Guard is opened, wheel rotation will stop immediately.
• Select the Spindle Hub Cone
[N]
that best fits the center hole of the wheel.
• Mount Spindle Hub Cone with the conical end outward
(FIG 7)
.
• Mount the wheel/tire on to the Main Drive Spindle with the center hole over the conical portion of the Spindle Hub Cone
(FIG 7)
.
• Place the Quick-Release Hub Wing Lock
[P]
on the Main Drive Spindle by spinning inward to tighten wheel/tire in place or by rotating the Spring-Loaded
Quick-Release Ears in a Clockwise direction while sliding onto threaded shaft
(FIG 8)
.
Apply moderate hand pressure to keep the wheel/tire from spinning while tightening the Hub Wing Lock.
FIG. 8
P
✓
FIG. 7
Rotate
P
✓
N
✓
