Eastsign
8
O
P
E
R
A
T
IO
N
GP
R
O
C
E
D
U
R
E
S
5.3
、
Pre-heating
Pullthehandlesontheheating-boxes,andmaketheheatingoven
turn over upward. Press the“
ON”at the upper position of Heater
Control Switch, the indicator will be on, the axial fan of the drying
oven will start to work. There is hot wind from the bottom of the
drying oven, and the drying oven will pre-heat for about 3-8
minutes.Themachinestartstoworkwhenthesettingtemperature
ismet.
5.4
、
LaminatingProcess
5.4.1
、
Turn on the liquid pump switch (Fig.4); open the valve for liquid
supply. Spread some liquid on the surface of the picture. (It is
bettertolettheliquidcontactthetwoliquidstoppers.)
5.4.2
、
PresstheDirectionSwitchofthecollectingrollerforpicture(Fig.4)
at its the upper position“
F”to let the roller for collecting picture
rotatinginclockwise.PresstheWork-State-SelectionSwitchofthe
rollerforcollectingpicture,andturnthespeed-adjustingbuttonin
clockwise to 25%. Put down the drying oven, the picture start to
move ahead to begin to laminate. During laminating, care should
betakentoadjusttemperatureandspeedtoensurethelaminated
quality (the picture surface shall be dry and without distortion.).
Addsomeliquidintothetanktoavoidliquidrunout.Suggestions:
In order to obtain suitable temperature and speed setting values
and be familiar with machine's functions, it is recommended that
we can use a test piece of picture instead of the useful picture to
avoidanylossduetofailureoperation.
5.4.3
、
Stop Heating: Stop the liquid supply when the end of picture
entering the heating-boxes, and clean out the glue in the guiding
paper (or cloth) with wet cloth. Turn off the drying ‒box switch
(Fig.4) when the end of picture coming out of the heating-boxes,
a n d t h e i n d i cato r l a m p w i l l b e o u t . T h e a ct u a l m ea s u re d
temperaturewilldrop;theheating-boxeswillstopwork.Atthis
