EASTONTECH FEK-06M, Operation Instruction Manual, Page: 6 / 8

■
Service conditions and notes
- The fluid used for the equipment: compressed air.
- Use environment and fluid temperature: 5 ~ 60
℃
.
- The medium used for the equipment cylinder can be used only after it is filtered by
filter element of 40 um and above (i.e., the air source used for the cylinder shall be
used after it is filtered by air filter
- The corresponding air tube and joint shall be chosen for the pipeline connecting to the
equipment and internal dirty objects must be removed, in order to prevent the sundry
into the cylinder from damage to the cylinder.
- When crimping big square terminals, please ensure the air source and air pressure is
sufficient.
- If it is used in low temperature environment, the antifreeze measures shall be taken to
prevent the water in the system from freezing.
- Suggestion: The medium used for the cylinder can be used after the lubricant is filled
(i.e. the oil sprayer is installed in the air supply pipeline; It is proposed to use the
turbine oil No. 1 ISOVG32).
■
Maintenance and Storage Notes
- Before using, the connection positions of the sliding shafts of the machine should be
filled with a little lubricating oil to extend the service life of the machine.
- The product is the pneumatic product, it shall not be placed in the high temperature
and low temperature, high humidity environments no matter when use or store.
- In no use, it shall be kept clean and dry to avoid rust, the removed intake and exhaust
ports shall be blocked with the dust cap or taken the other dust prevention measures
■
Crimping die sets replacement method
- Shut off the air source to avoid the risk caused by the improper operation.
- Remove the screws which fixed the crimping die sets with the screwdriver supplied
together with the machine.
- Replace it with the required crimping die sets, and then fasten the screws again.
■
Notes when loading and unloading the crimping die sets
- The crimping die sets are used in pairs, when installing, please confirm that the upper
and lower die sets are in the centered positions.
- After installing the die sets, slowly step on the foot air valve, so that the machine can
operate at low speed, to check the installation situation of the crimping die sets.
4