EASTONTECH FEK-06M, Operation Instruction Manual, Page: 5 / 8

Operating instructions
It is recommended for the user to read this instruction manual carefully before using this
equipment, to be familiar with the use method and technology performance indexes of
the equipment.
■
Using method
Please connect to the air tube in accordance with the corresponding markings of the
equipment and accessories,
- Open the air source, the crimping can be conducted only after the clamp head of the
equipment in open state.
- After the fixture is installed, slowly step on the foot air valve so that the machine can
operate at low speed, to check the installation situation of the fixture.
- Place the crimping terminal in the corresponding fixture position, step on the foot air
valve, release the air valve after the completion of the crimping.
- The crimping speed can be manually controlled according to the speed when stepping
on the air valve, or adjusted by selecting the matched pipe joint with the throttling valve.
FEK-06M is the first crimping machine in the world for crimping the insulated terminal
of 0.5~10mm
2 with the air source. The machine can provide extremely convenient and
quick service for the user to greatly promote the practical value and convenient use
of the tools. The parts of the crimping machine are made of the special alloy steels by
many precision stamping after heat treatment, the sections are smooth and flattened.
The crimping die sets are made of super hard tool steel with the advantages of long life,
accurate aperture size and good crimping effect. The terminal mode can be hexagonal
type or point type after crimping with different crimping die sets. Each crimping machine
shall be equipped with 1 set of crimping dies, the customers can select different
crimping die sets according to different requirement.
Product introduction
This product uses the double-acting standard cylinder driving, has the high efficiency
and high quality advantages on the crimping force and crimping speed. It is applicable
for crimping large quantities of terminals. If the diversified forms of crimping terminals
are used, this product shall be chosen because the crimping die sets is interchangeable
with the crimping die sets of the hand crimping tools produced by the company. Our
company have many kinds of crimping die sets for selection.
3
Operation Instruction for FEK-06M