72
Form E-551
a)
Hit the Cut Down button on the UIT and verify the corresponding LED lights for desired tool.
b)
Try firing the tool manually by pressing gently with the end of a small paper clip into the small hole
at the top front of desired air valve. Each solenoid can be manually fired by pressing the individual
button.
c)
Make sure all yellow wires are securely attached to the Y-car slice output card. If any wires are
loose refer to schematic for proper location otherwise call Eastman technical support.
5.
The Tool delays coming down and misses beginning of marking or cut.
a)
Check the voltage on the 24V DC power supply. Make sure it is a minimum of 24V DC.
b)
Check solenoid connectors at Y-car slice I/O Board. Make sure you have a good connection.
c)
Try cycling a different air valve. If the other air valves are working properly the bad air valve should be
replaced.
Problem: Gantry goes past limit and hits End Stops
Description of Problem:
While cutting certain files, the conveyor begins to pull and gantry runs to end of table and hits end stops.
Troubleshooting:
1.
Check the table limits to make sure that each tool can reach to the laser position without hitting a table
limit.
a)
Click on “eCut” then click on “Check Reference” in the main eSuite menu
b)
After the table finishes zeroing, press “Yes” on the check table limits pop up box
c)
On the Touch Screen Keypad press the “Y” then the “ENTER” key (ENTER key on keyboard)
d)
The table will check the table limits to make sure each tool can reach within the set limits.
e)
If the Y-car or Gantry hit a limit switch, reset the table limits in eSuite by clicking on eCut then
“Machine Settings” and finally the “Size” tab. Adjust “Table Top”, “Table Bottom”, Table Right” or
“Table Left” limits as required.
