microBrute DRSSTC Tesla Coil Kit
November 2019, Rev 5
− 25 −
Copyright © 2011, Eastern Voltage Research, LLC
microBrute DRSSTC Instruction Manual
95. Install C41, 1uF or 1.2uF, 630V capacitor. There is no polarity on this
capacitor. These are large red capacitors marked either 105K or 125K.
96. Attach Q41, IXGN60N60C2D1 IGBT, to the heatsink using 8-32 x 5/16”
panhead screws as shown in the figure below. It is required to use thermal grease
(not supplied) in between the heatsink and the IGBT to ensure proper heat
transfer.
IMPORTANT: Ensure notch location is oriented as shown in the
figure below.
97. Attach Q42, IXGN60N60C2D1 IGBT, to the heatsink using 8-32 x 5/16”
panhead screws as shown in the figure below. It is required to use thermal grease
(not supplied) in between the heatsink and the IGBT to ensure proper heat
transfer.
IMPORTANT: Ensure notch location is oriented as shown in the
figure below.
98. Install C101, 0.15uF, 2000VDC capacitor. To ensure proper electrical stand-
off, install C101 as shown in the figure below.
