Advanced RGB LED 1.0 Kit
December 2013, Rev 1
− 11 −
http://www.EasternVoltageResearch.com
Advanced RGB LED 1.0 Kit
9. Install C1, 0.33uF capacitor(marking BC334 or 334 or similar)
10. Install C2, 0.1uF capacitor (marking BC104 or 104 or similar)
11. Install U1, MC78L05AB voltage regulator (marked MC78L05AB) This IC
needs to be orientated properly. Please insert U1 into the board with the flat edge
of the IC orientated according to the silkscreen layout drawing.
12. Install an 8-pin DIP socket into the U2 location. Note that one end of the DIP
socket is marked by a notch; this end MUST be oriented as shown on the PCB
layout.
DO NOT INSTALL PIC12F683 at this time!
13. Install Q1, BS170 MOSFET transistor (marked BS170) This transistor needs
to be orientated properly. Please insert U1 into the board with the flat edge of the
transistor orientated according to the silkscreen layout drawing.
14. Install Q2, BS170 MOSFET transistor (marked BS170) This transistor needs
to be orientated properly. Please insert U2 into the board with the flat edge of the
transistor orientated according to the silkscreen layout drawing.
15. Install Q3, BS170 MOSFET transistor (marked BS170) This transistor needs
to be orientated properly. Please insert U3 into the board with the flat edge of the
transistor orientated according to the silkscreen layout drawing.
16. Install pushbutton, PB1.
17. Install the 9V battery connector to the PCB board. The red wire connects to
the terminal pad labeled VIN on the PCB while the black wire connects to the
terminal pad labeled GND.
Congratulations! You have just completed your Advanced RGB LED 1.0 kit. Please
take a few moments to look over the board and ensure that all the components are
installed properly with the correct orientation. Since some of the parts may be unfamiliar
to you, you may want to be extra sure that they have been inserted correctly. After you
are sure that everything seems to be properly installed, move on to the set-up and testing
section.
