12
13
Precautions
Trouble
Cause
Solution
Will not start
External hot or
can smell hot
Clothes too dry
Clothes shrink
Hairball on clothes
•
Power cut.
•
The power plug is not plugged tight.
•
Dry clothes exceed.
•
The temperature fuse is cut.
•
The lint filter is dirty.
•
The uptake or exhaust duct is dirty.
•
Too dry
•
The clothes in machine are too full.
•
Not to take out the clothes in time
when finish.
•
The clothes don’t assort properly.
•
The temperature is enacted too high.
•
It is right for synthetic fibre and
permanent press fibre causing
hairballs. This is because the right
rub causing.
The sound of dryer when runs can cause
•
Buzzer of vibration: Due to heavy wet clothes’ turning and bumping, and this will cause
accordingly.
•
Air bumping: When drying, machine will generate steam which will come out from pipe
this will cost bumping with the bottom of inner tub.
noise
and
•
Wait for switching on electricity.
•
Check the power socket, make sure plug
tight.
•
The clothes in drier must be after spining,
drying clothes can not exceed 6kg.
•
Please career man restore the temperature
fuse.
and
•
Make sure clean the lint filter in time.
•
Clean out the stem.
•
Make sure the clothes are not too full.
•
Take out the clothes immediately when
finish.
•
See page 7.
•
Observe the maintenance label on clothes.
•
Observe the maintenance label on clothes,
if easy to shrink, should examine the
when dry. Take out the clothes
damp for too dry. Then hang the
until full dry.
clothes
when tiny
clothes
•
Use fabric softener lubricate fibre,
spray settled gule on cuff and
iron clothes. Turn the
for reducing rub.
please
neckline
when
sarcenet out
Precautions
Safety reset
Safety reset
1. These dryers have a safety cut out switch which is activated by temperature.
2. The safety reset button is on the backboard. If your dryer not heating this button must
be reset before the dryer will operate again. You may need to wait 10 minutes for
cooling to occur.
3. The most common reason for the dryer to overheat is a blocked filter. Clean the line
filter after each load to prevent overheating of the dryer.
It will only be necessary to press the safety reset button if the dryer not heating. Allow
the dryer at least 10 minutes to cool down before pressing the button .Press the white
button in until you feel the reset click. Cleaning the filter after each load will avoid
repetitive operation of the safety cut out switch.
The cut out switch may operate for the following reason:
1. Lint filter is blocked.
2. Exhaust outlets blocked at the back of the dryer.
3. Poor ventilation in the laundry or room-open a window or door
4. Lightweight garment eg. handkerchief, sucked over the filter.
Safety Reset Button
Use your finger or a pencil to press the button in until you feel it click.
This marking indicates that this product should not be disposed with other
household wastes throughout the EU.
To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
V.1
V.1
