• Go to the commissioning parameter setting page. Check that
"C0"
is displayed in the temperature
display area. Press ▲ and ▼ buttons to change the
"commissioning parameter Code"
.
• Once the
"commissioning parameter Code"
is selected, press
(Confirm) button to go to the
specific commissioning parameter settings, and then press ▲ and ▼ buttons to adjust the value.
Press
(Confirm) button to save the value and complete the commissioning parameter
setting.
• Press
(Cancel) button
to return to the previous page until you exit
commissioning parameter
settings. Alternatively, system will exit the
commissioning parameter settings page if there is no
operation for 60 seconds.
• When it is in the commissioning parameter settings page, the wired controller does not
respond to any remote control signals.
• In the commissioning parameter setting page, the
(Mode),
(Fan speed),
(Swing),
(Function) and
(ON/OFF) buttons
are not available.
• Commissioning parameter can be set when the unit is on or off.
• Press and hold
(Function) and
(Mode) buttons
for 5 seconds to go to the page for
commissioning parameter settings.
3. Commissioning Parameter Settings
Figure 7.3
26
adjust the
address to the required value (address range is 0-63). press
(Confirm) button
to send the current address value to the indoor unit. In 60 seconds, the wired controller will
exit the address setting page, or press
(Cancel) button to exit the address setting page.
• In the address setting page, the wired controller will not respond to any remote control signals.
• For cooling only operations, please do
corresponding settings as described .
Note:
V.2
Summary of Contents for ECRP86EKD
Page 2: ...V 2...