5.
Install Lower Handles onto Axle to both
sides as shown above. Now insert 1-1/2” bolt
through first hole in lower handle, then
through frame brace, and finally into the
threaded connector in the Cross Brace.
[NOTE: Dimples on frame braces must be
facing toward gearbox as shown.]
DO NOT TIGHTEN YET.
Next insert 1-1/2” bolt through other end of
frame brace and through second hole in frame
install locknut.
DO NOT TIGHTEN YET.
Now insert 2-1/4” bolt through second hole in
lower handle and through first hole in frame.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2
4.
Install Gearbox by inserting the pinion shaft into hole in center
of hoppers bottom. The word
“FRONT”
on the gearbox must
point to
F
RONT
of the hopper.
3.
Install impeller onto pinion shaft. Insert 1/8” x 1-1/4” cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out. Next, install the Cross Brace
through the Gearbox Brace as shown above.
