Assembly and Operation Instructions
2150_M51257_RevJune2021_new
PAGE 6
Step 10:
Take the shortest end of the PIVOT
ROD and insert into the SHUT-OFF PLATE. You
may have two holes, use the SHUT-OFF PLATE
hole towards the back of the spreader. Insert it
through the hole (downward) and then rotate 90
degrees so that end is turned parrellel as shown.
Step 11:
Locate the PIVOT ROD backet, insert
the other end of the PIVOT ROD through the back
of the PIVOT ROD BRACKET as shown (see
below).
Step 12:
Install HANDLE SHAFT to LOWER HANDLEs and PIVOT & BRACKET assembly as shown. Using 2
″
bolts and
locknuts.
TIGHTEN BOLTS AND NUTS NOW.
Step 13:
Install flattened end of CONTROL ROD
in to LEVER on GAUGE as shown. Turn to lock in
place.
Next push LEVER forward to setting “0”.
Align CONTROL ROD with hole in PIVOT BRACKET,
pull LEVER backward to insert CONTROL ROD
through hole in PIVOT BRACKET.
Step 14:
Install (1) 1/4-20 regular nut (not a
locknut) on to CONTROL ROD as shown.
X-SECTION SHUT
OFF PLATE
Through hole,
then rotate
