PAGE 4
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product to be free of defects in original workmanship and materials for
a period of 5-Years to the end user with the original purchase receipt. If a manufacturing non-conformance is
found, Earthway Products, Inc. at its discretion will repair or replace the part(s) or product at no charge provided
the failure is not the result of incorrect installation, mishandling, misuse, tampering, or normal wear and tear as
determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along with
the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty.
Do not return any product without first receiving authorization from Earthway Products, Inc. To seek remedy under
this warranty, contact Earthway Products, Inc. at 574-848-7491, [email protected] or write to Earthway
Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature of the manufacturing defect.
SPECIFIC
LIMITATIONS:
This warranty covers only the part(s) or product; any labor charges associated with repair or
replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and
ice melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product
degradation or failure due to corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a
preventative measure, coat all metal parts (inside of tubing) with a light oil or silicon spray.
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader.
1. Obtain proper setting for material to be used from the RATE SETTING MATRIX included with this spreader.
2. Move stop bolt on rate gauge assembly to the proper setting for the material that you are spreading.
3. While pushing spreader forward, pull the Control Lever back to stop bolt.
4.
To stop, push lever forward to close flow holes before you stop moving.
5.
When finished, empty any remaining material from hopper.
6. Thoroughly wash spreader and allow to dry before storing. Spray all metal surfaces (inside & outside) with WD-
40 or other light oil to help prevent corrosion.
SideSpred-Control
™
OPERATION
The
SideSpred-Control™
lever is located on the back of the hopper at the bottom. To operate the
SideSpred-Control
™
, slide the control lever from the left, to the right. This will activate the
SideSpred-
Control
™
for a
PARTIAL
spread pattern and prevent material from being spread to the left side of the spreader.
Position the left wheel of your spreader 12”-16” from the sidewalk, flowerbed, or driveway and spread as normal.
When you have completed this spreading pass, open the
SideSpred-Control
™
by sliding the control lever from
right to left, for a
FULL
spread pattern.
The
SideSpred-Control
™
is a new innovation that eliminates the need to use a side deflector, which can
adversely affect your application rate, to prevent material from being spread into flowerbeds, on sidewalks, or
driveways. The
SideSpred-Control
™
maintains the correct application rate while it is activated, giving you
excellent results in seeding or spreading while controlling the spread pattern on the left side of the spreader.
The
SideSpred-Control
™
is an 2600APlus exclusive.
NEW ~ NOUVEAU ~ NUEVO
