EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS
4
WOOD AD/OR GAS FIRED COMBIATIO PIZZA OVE
OPERATIG ISTRUCTIOS
WARNING
:
READ ALL INSTRUCTIONS CAREFULLY. IMPROPER USE OF THIS APPLIANCE MAY RESULT IN A BUILDING FIRE
OR PERSONAL INJURY. INSTRUCTIONS MUST BE READ AND THOROUGHLY UNDERSTOOD BY ALL OPERATING
AND SUPERVISING PERSONNEL. WATCH TRAINING VIDEO FOR VISUAL OPERATION INSTRUCTIONS.
THIS OVEN IS INTENDED FOR ATTENDED OPERATION BY TRAINED AND QUALIFIED PERSONNEL ONLY.
THIS OVEN IS A HEAT PRODUCING APPLIANCE AND MAY CAUSE SEVERE BURNS IF TOUCHED.
DO NOT OVER FIRE. IF FLAME SPILLS FROM THE DOOR OPENING OR OVEN TEMPERATURE EXCEEDS 1000
DEGREES FAHRENHEIT, YOU ARE OVER FIRING.
THIS UNIT IS DESIGNED AS A GAS OR GAS/WOOD FIRED OVEN. DIRECT FOOD CONTACT WITH THE HEARTH IS
RESTRICTED TO PIZZAS AND BREAD PRODUCTS ONLY. FOR OTHER FOODS REFER TO MANUFACTURE
OPERATION GUIDELINES.
ALL WOOD EMBERS BURNED INSIDE THE OVEN MUST BE PLACED DIRECTLY ON
THE OPPOSITE SIDE OF THE GAS BURNER (SEE DIAGRAM). WOOD SHOULD BE USED ONLY FOR FLAVORING
AND AESTHETIC VALUE, THE MAIN SOURCE OF HEAT SHOULD BE SUPPLIED BY THE GAS BURNER
KEEP A PROPER FIRE EXTINGUISHER CLOSE TO THE OVEN AT ALL TIMES. EXTINGUISHER MUST BE RATED
FOR USE ON WOOD FIRES. INSTRUCT ALL PERSONNEL ABOUT LOCATION AND USE OF THE FIRE
EXTINGUISHER AND PROPER FIRE EMERGENCY PROCEDURES.
a-
Before starting, turn "ON" exhaust fan and make-up air blowers.
b-
Place a small amount of wood and kindling on the hearth over a fire-starter block. Light fire-
starter. At any time do not use more than four pieces of wood,
c-
CAUTION: NEVER USE GASOLINE TYPE LANTERN FUEL, KEROSENE, CHARCOAL
LIGHTER FLUID OR SIMILAR PRODUCTS TO START OR "FRESHEN UP" A FIRE IN THIS
OVEN. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE OVEN WHEN IN USE.
d.
When the kindling is burning well, add larger pieces of firewood. USE WELL-SEASONED OR
DRIED WOOD ONLY.
e-
Continue to add fuel as needed to maintain the desired heated rate, being careful to never
over fire the unit.
f-
Whenever fuel is added, the fire may be poked and stirred with a wood handling tool. This will
allow air to move through the fuel bed for proper combustion.
