EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS
8
GAS BURNER CONTROLS
COTROL BOX
1
O/OFF
—MAIN SWITCH TO TURN BURNER ON AND OFF
2
HI/OFF---
BURNER WILL REMAIN ON HIGH FLAME UNTIL DESIRED TEMPERATURE IS REACHED. ONCE
DESIRED TEMPERATURE IS REACHED BURNER WILL SHUT OFF. WHEN TEMPERATURE FALLS BELOW DESIRED
TEMPERATURE HI FLAME WILL COME BACK ON.
3
HI/LO---
BURNER WILL REMAIN ON HIGH FLAME UNTIL DESIRED TEMPERATURE IS REACHED. ONCE
DESIRED TEMPERATURE IS REACHED BURNER WILL GO TO LOW FLAME. WHEN TEMPERATURE FALLS BELOW
DESIRED TEMPERATURE HI FLAME WILL COME BACK ON.
TEMPERATURE READOUT COTROLS
4
BLACK DIAL KOB
—USED TO CHANGE TEMPERATURE. BY ROTATING CLOCKWISE OR COUNTER-
CLOCKWISE.
5
RED BUTTO
—USED SIMULTANEOUSLY WITH BLACK DIAL KNOB TO SET TEMPERATURE.
SEE PAGE LABELED SWITCH DIAGRAM LAYOUT
OPERATION
FIRIG OVE (OTE: DO OT CLOSE DOOR WHILE OVE IS BEIG FIRED)
MAKE SURE GAS CONTROL VALVE IS IN THE ON POSITION.
WHILE PRESSING RED BUTTON, TURN BLACK KNOB TO DESIRED TEMPERATURE. THIS SHOULD BE
ABOUT 650 F TO 750 F.
MOVE SWITCH TO HI/LOW POSITION.
TURN MAIN POWER SWITCH TO ON. A SPARK IS GENERATED WHICH WILL IGNITE THE GAS AT THE
MAIN BURNER INSIDE THE OVEN.
DAILY THERMAL CLEAIG PROCEDURES:
•
INCREASE OVEN TEMPERATURE TO 850 DEGREES
•
LEAVE OVEN DOOR SLIGHTLY OPEN, AT LEAST THREE INCHES. THIS IS DONE BY ROTATING
OVEN DOOR AT A 45-DEGREE ANGLE. OVEN DOOR SHOULD NEVER BE CLOSED WHEN BURNER
IS ON. OVEN INTERIOR WILL TURN BLACK IF DOOR IS CLOSED WHILE BURNER IS ON. A BACK
FLASH CAN ALSO OCCUR.
•
AFTER TWO HOURS TURN OVEN OFF AND CLOSE OVEN DOOR.
