MiniMe DSP P63 Manual 11
CONNECTING YOUR MINIME DSP
P63 SUBWOOFER
Low Level RCA Setup - Single Subwoofer
This is the best way to drive an audio
signal to your MiniMe DSP P63 sub-
woofer. Today, all signal processors (5.1,
6.1, etc.) come equipped with built-in
pre-amplifier outputs (RCA) that in-
clude a subwoofer output. Generally,
the SUB PRE OUT is in a mono format.
Connect the SUB PRE OUT from your
audio/video processor to the MiniMe
DSP P63 LOW LEVEL INPUT using a “Y”
RCA cable.
We strongly recommend that you use
the best available RCA connectors and
cables. High quality cables are normally
triple shielded and the connectors are
gold plated with forceful grasping.
When using this connection, the MiniMe
DSP P63 only receives bass signals from
the source. Therefore, the crossover
frequency should be set at max value.
SUR. BACK
CENTER
FRONT
SURROUND
PRE OUT (SINGLE)
SUB
BACK OF
TYPICAL A/V
RECEIVER OR
PROCESSOR
DIGITAL
600 WATTS
PLACING YOUR SUBWOOFER(S)
Dual Sub Setup With Mono Signal
This is a BETTER setup. In a dual sub-
woofer setup, the sub-harmonic fre-
quencies (black arrow) always move
towards the middle of the room while
the lows, mids, and highs follow the ac-
tion (gray arrow).
Notice the breakaway and image sepa-
ration is less in this setup than the sin-
gle subwoofer setup.
