EarthQuake 7055, Operating & Parts Manual

Page: 13 / 32

1
ARDISAM
800-45-6007 www.ARDISAM.com
ADJUSTMENTS
DEPTH REGULATOR LEVER
Tilling depth is controlled by the height of the depth
regulator lever.
To.adjust.tilling.depth.
1..Remove.detent.pin.
2..Raise.the.depth.regulator.lever.to.position.tines.at..
. chosen.tilling.depth.
..Align.hole.in.depth.regulator.lever.with.hole.in.depth..
. regulator.bracket.and.replace.detent.pin.
Always set the depth regulator lever in the
transport position before starting engine, that
is, place the detent pin in the highest hole of the
depth regulator lever.
Do not adjust tilling depth unless drive safety
control levers are released to neutral position.
depth regulator
bracket
depth regulator lever
detent pin
Depth Regulator Lever Down = .Shallower.tilling..
Place.the.detent.pin.in.the.top.hole.of.the.depth.
regulator.lever.for.shallowest.tilling.
Depth Regulator Lever Up =
Deeper.tilling..Place.the.
detent.pin.in.the.bottom.hole.of.the.depth.regulator.
lever.for.deepest.tilling.
WARNING
!
WARNING
!
BELT TENSION ADJUSTMENT
Proper.belt.tension.is.critical.to.good.performance..
After.1/2.hour.of.operation,.all.cables.may.have.to.be.
adjusted.due.to.initial.stretch..Thereafter,.check.tension.
after.every.2.hours.of.operation..
To increase belt tension:
..
1..Loosen.upper.jam.nut..Turn.nut.up.cable.in.1/8”..
. increments.
2..Tighten.lower.jam.nut.
..Check.adjustment.
This.procedure.can.be.repeated.until.conduit.
adjustment.bolts.have.no.more.adjustment.left..If.no.
more.adjustment.can.be.made,.belt.may.have.to.be.
replaced.
reverse cable
forward cable
upper jam nut
lower jam nut