OPERATOR INSTRUCTIONS ANd PARTS
CRT Models 6015V, 6015VCE, 6015BCE
Page 17
GetEarthquake.com
800-345-6007
LUBRICATION
Proper lubrication of moving mechanical parts is critical for proper care and
maintenance. oil the moving parts at 10 hour intervals using a 30 weight oil.
CLEAN TINE AxLE ShAFT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Tip the tiller forward. Block the tiller in position so that it rests on the
engine mount and the tines are exposed.
4. Remove all vegetation, string, wire, and other material that may have
accumulated on the axle between the inside set of tines and the seal
on the transmission housing.
5. Tip the tiller back to a level position.
6. Replace spark plug wire.
STORAGE
PREPARE FOR STORAGE
Follow the steps below to prepare your tiller for storage. Read your engine
manual for detailed instructions on preparing the engine for storage.
1. Protect wheels and axles from rust:
- Remove lock pin and slide wheel off hub.
- Coat the axles lightly with axle grease.
- Slide wheel back on hub and insert lock pin.
2. Drain fuel system completely following engine manufacturer’s
instructions or add fuel stabilizer to prevent fuel from gumming up
during extended storage period.
3. While engine is still warm, drain the oil from the engine. Refill with
fresh oil of the recommended grade.
4. Clean external surfaces, engine and cooling fan.
5. Remove spark plug, pour one ounce of SAE 30 oil into spark plug hole.
6. Plug hole and pull starter cord slowly to distribute oil evenly in cylinder
head area.
7. Reinstall spark plug.
8. Transport unit to a suitable storage location. If you have chosen to
use a fuel stabilizer and have not drained the fuel system, follow all
safety instructions storage precautions in this manual to prevent the
possibility of fire from the ignition of gasoline fumes. Remember,
gasoline fumes can travel to distant sources of ignition and ignite,
causing risk of explosion and fire.
9. If there is any possibility of unauthorized use or tampering, remove
the spark plug and store it in a safe place before storing the rototiller
unit. Be sure to plug the spark plug hole to prevent foreign material
from entering.
dO NOT STORE TILLER IN AN UNvENTILATEd AREA
WhERE FUEL FUMES MAY REACh FLAME, SPARkS,
PILOT LIGhTS OR AN IGNITEd OBjECT. dRAIN FUEL
OUTdOORS AWAY FROM ANY IGNITION SOURCES.
USE ONLY APPROvEd FUEL CONTAINERS.
WARNING
!
