6
LEVELING THE TABLE
Not all commercial and residential floors are perfectly level. The Ellora
™
has foot glide levelers that
swivel into place against the floor. If your table is not already level when you remove it from the
shipping crate, follow these easy steps to level your table:
Step 1
Locate which foot glide leveler
is not even with the floor.
Step 3
Once the foot glide leveler is tight
with the floor, apply pressure on
top of the table to confirm stability.
Step 2
Rotate the foot glide leveler
clockwise or counter clockwise
to bring it to ground level.
PLACEMENT AND INSTALLATION
Once your table is placed safely on the floor, temporarily plug the table into a power outlet and using the
foot control, raise the table to waist height, which will make it easier for moving. Once the table is at the
desired height, unplug the power cable from the outlet and place the power cable along with the foot
control on top of the table to prevent a tripping hazard. For ease of movement and flexibility, your table
was built with two (2) rear wheels and two (2) front foot glide levers.
The following steps will guide you through safely moving your table to the desired location. We
recommend that at least two (2) people conduct the following steps:
Step 1
Locate the front and rear sections of the table frame underneath the upholstered top as designated by
the black arrows above. These are the recommended locations to hold when guiding your table to the
desired location (Diagram A1).
Step 2
Ensure there are no obstacles or tripping hazards in the way and carefully pull the table by the frame
into the desired location (Diagram B). A second person’s assistance is recommended to help push the
table from the opposite end.
Note Regarding Step 1:
Locate the front crossbar of the table frame where the foot glide levelers are located (Diagram
A2). This is a secondary recommended section of the frame to hold if you prefer, but may be more
difficult. If you choose this location, properly bend at your knees prior to lifting or pulling the table.
Do NOT pull or push the table from the upholstered top. Moving the table
in this fashion can damage the table and put too much pressure on hinges
or other components of the table. Damage made to the table by pulling or
pushing on the upholstered top may void the warranty (Diagram C).
Install this furnishing in treatment area not accessible to the public.
SAFETY ZONE: The treatment area must have 3-ft minimum unobstructed
clearance around entire table. Posting a notice is recommended to
maintain “Safety Zone Clearance”. The designated work area around the
table should be clearly marked off.
A1
A2
B
C
Summary of Contents for Ellora Vista Flat
Page 18: ...Name Purchase Date Model No Serial No OWNER S RECORD ...
Page 19: ...NOTES ...
