20
DO’S AND DON’TS
DO NOT:
Install or operate the stove or fireplace insert before reading this manual.
DO NOT:
Close the draft beyond the point at which the flames are completely extinguished.
DO NOT:
Open the stove or fireplace insert door without
fully opening
the draft first.
DO NOT:
Burn driftwood or wood that has been in salt water. This includes some mill ends and scrap lumber that has been floated in salt water
on the way to the mill. (This will void your warranty).
DO NOT:
Force oversized logs into the firebox as this may dislodge the baffle assembly.
DO NOT:
Close the door tightly during Burn-In Period.
DO:
Consult local building department if other than recommended clearances are desired.
DO:
Read instructions for the baffle boards occasionally to ensure you have not bumped or moved them out of place when loading wood.
DO
:
Check the chimney and baffle monthly to make sure they are clean.
DO
:
Burn seasoned, dry wood only! (RAIN = WET WOOD)
DO
:
Open the door frequently during Burn-In Period to keep gasket from adhering to the curing paint.
DO:
Enjoy the warm feeling of your new Earth Stove
™
appliance.
MAINTENANCE
GLASS REPLACEMENT INSTRUCTIONS
(Refer to
Figure 26
)
Step 1. Remove Door Assembly
- Remove the upper and lower hinge
pins by pressing the bottom of each hinge pin up, then pull out
from the top. Lift off door and place face down on a soft surface.
Step 2. Remove Glass Retainer Nuts (10 ea.)
- Using an 3/8” nut driver
or wrench remove the ten glass retainer nuts. To locate nuts,
peel back the door gasket as necessary.
Step 3. Remove Glass
- Carefully remove broken glass one piece at a
time (protective leather gloves are recommended).
Step 4. Clean Door Frame
- Clean the area of the door frame where the
new glass with gasket will be installed.
Step 5. Install New Glass Assembly
- Install the new glass with gasket
(use only factory supplied 5mm ceramic glass with gasket. Do
not substitute).
Step 6. Reinstall Retainer and Nuts
- Carefully reinstall the glass retainer
and nuts. Be very careful not to overtighten the nuts (this could
result in glass breakage when the stove is hot).
Step 7. Reinstall Door
- Align hinges on door frame with corresponding
hinge holes on the face of stove. Reinstall the upper and lower
hinge pins from the top.
Figure 26 - Glass Replacement
Faceplate
Door Gasket
Glass Gasket
Glass
Door Back
Handle Assemble
Nuts (10 places)
