22 of 39
Dated 17/09/19 V1.2
ESP-HC-DHW 11DC
ESP-HC-DHW 17DC
Repeat the instructions above to set period 2 (the first ‘off’ time) as follows.
Enter timer setting, select week, and period 2, press
to confirm. The Hour icon will flash:
As before, use the ▲ ▼ keys to set the hour and the
key to confirm. The minute value will then flash and
the ▲ ▼ keys can be used to set the required value, pressing the
key to confirm. If the setting value is
valid, the timer icon will flash.
As before, press the up key, and the timer icon will disappear if the setting is valid. Press the
key to
confirm. Press the down key and if the timer icon disappears, the setting is not valid
Repeat the process for timers 3 (ON), 4(OFF), 5(ON) and 6 (OFF) as required, remembering to set ‘pairs’ of
off and on.
Press the On button to confirm and exit.
To clear the timers, press the up and until the controller beeps.
4.4.5 Night mode
For most installation, Night Mode is not recommended.
If night mode is set (parameter 47=1. 0=off), the Solis units engage a ‘set back’ period:
Space heating flow temperature will decrease by 2°C.
DHW heating (if applicable) will increase by 3°C.
If Cooling has been enabled, set temperature for cooling will increase by 2°C.
The fan speed will be set to low.
4.4.6 Auto mode
If this mode is selected
and
cooling has been enabled by the factory, the Solis will run in heating mode
below an Ambient temperature of 15°C and in cooling mode in temperatures above 25°C. In Auto
mode, in Ambient temperatures between 15 and 25°C, it will run in the latest mode selected i.e. cool if it
was previously in cooling mode or heat if it was previously in heating mode.
