SET UP
• Fill the Paint Container (12) with the product to be sprayed. Stir well (as mentioned previously) and strain to remove any bits which will interfere
with a smooth consistent spray.
• Make sure the Paint Container Seal (10) and Pick-up Tube (11) are firmly fitted into the base of the Spray Gun.
• Screw the Paint Container (12) to the base of the Spray Gun and tighten accordingly.
• Start with the Paint Flow Adjuster (9) at its minimum setting so the Trigger can not be pulled. Do not forget that
the Paint Flow Adjuster controls the quantity of paint sprayed (Fig.4).
• Uncoil the air Hose and attach it to the back of the Spray Gun and the other end to the Spray Station.
• Uncoil the power cable and attach the plug to the mains supply.
• Switch the Spray Station on. This will immediately cause some air to be produced, which is quite NORMAL.
However, none of the product will be sprayed until the Spray Gun Trigger is pulled.
•
Very important:
when spraying for the first time, we recommend that you always leave the motor unit to run for
1 to 2 minutes before applying the product. Do not forget that the Paint Flow Adjuster controls the quantity of
paint sprayed (Fig.5).
ALWAYS MAKE SURE THAT THE MOTOR UNIT IS ON A RIGID SURFACE AND FREE FROM DUST.
4
SPRAYING
HORIZONTAL
VERTICAL
ROUND
3 Spray Patterns
Horizontal and Vertical Spray with varying widths
Round Spray
Vertical and Horizontal for normal sized jobs
Round for small and precise jobs
Fig.6
Fig.7
Fig.5
PREPARATION
• Carefully cover areas which are not to be painted with a plastic cover and protective tape.
• Wear a suitable mask when spraying products (and make sure there is adequate ventilation in the room when working indoors).
• Clean the surface you are going to paint. As well as being clean, it must also be dry and smooth.
• Practice first on some old wooden planks to make sure you are holding the Spray Gun correctly.
• We recommend you wear protective clothing.
• Stir the paint well using a mixer where possible.
• Make sure there are no solid particles in the paint.
• Many products can be sprayed without being thinned. However, if the application is not good, thin the product progressively in stages of 5%.
• Most paints can be sprayed by being thinned just a little, e.g. by 5% or 10%.
• Some thick paints such as outer wall paints and certain undercoats will need to be thinned by 20% or 25%.
• Use water to thin a water-based product.
• Use appropriate thinner to thin solvent-based products.
• Certain manufacturers will indicate on the can whether a specific thinner is to be used.
• Certain paint manufacturers have specific paints available for HVLP application.
Dip the viscosity cup into the material and fill up. Time how long it takes for the paint to stop being a continuous flow, from
the bottom of the cup (Fig.4). If the paint requires thinning, start with a 10% dilution of the paint. To do this, part fill a con-
tainer with one litre of paint. The viscosity cup supplied with the unit holds 1/10 of a litre, block the hole in the viscosity
cup and fill up with the required thinner. Add the thinner to the paint and stir, measure the viscosity. If the paint requires
further thinning, dilute the paint by another 5% (5% will be equal to half a viscosity cup) with the required thinner and
measure the viscosity, if the paint is not at its recommended viscosity, repeat the above step.
12
3
1
2
4
5
6
7
8
9
10
11
DILUTION
Fig.4
V0082 09-09 A4 Multi:Layout 1 12/10/09 10:28 Page 4
