EC Declaration of Conformity
We declare that the unit: WD1200P conforms to: 73/23/EEC, EN60335-1 & 2-2-1995 & 89/336/EEC,
EN55014 - 1, EN55014 - 2
Tim Hopper Technical Director
ACCESSORIES AND SPARE PARTS
A range of spare parts are available for the CombiPowerVac
TM
. To order please contact our helpline on
01483 454666. Opening Hours:
Monday-Thursday
08.30-17.00
Friday
08.30-16.30
WDACC2 - Deluxe Floor Head
with hard floor, brush and squeegee attachments. Wider head for
greater coverage, suitable for carpets and faster pickup of debris and spills.
WDACC14 - Wide Bore Tool Kit
for larger debris such as rubble and leaves.
WDACC15 - Mini Cleaning Set -
ideal for cleaning/blowing computers, video recorders, air vents in cars.
WDACC16 - Sink Deblocker -
clears blockages from sinks, baths and showers.
MAINS CONNECTION
This unit is supplied with a mains lead fitted with a plug. If the supply cord is damaged, it must be
replaced by a special assembly available from Earlex Ltd. or our appointed agents.
The replacement supply cord is Part No. WD0160
Your unit has been supplied with a mains lead with a fitted plug. This is identified by the fuse holder in the
base of the plug. Please read the following safety instructions before use.
1. If the fitted plug is cut off from the mains lead then the plug must be disposed of safely.
NEVER
under any circumstances insert such a plug into a 13amp socket.
2.
NEVER
under any circumstances use the appliance or mains lead without the fuse cover fitted.
This is the little cover fixed into the base of the plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our
helpline
4. A replacement fuse must be rated at 13amp. These must be manufactured and approved to BS 1362.
5.
IF IN ANY DOUBT CONTACT AN ELECTRICIAN.
If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring instruc-
tions below, and will need to be used with a 13amp fuse. If in doubt consult an electrician.
WARNING - THIS APPLIANCE MUST BE EARTHED
If you are using an extension lead it must be rated at a minimum of 13 amps and fully unwound.
Do not operate with a lead rated at less than 13 amps as this will cause premature failure of the
unit which is not covered by the guarantee.
As the colours of the wires in the mains lead of the application may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the lettter E or by the earth symbol, or coloured green or green or yelllow.
The wire which is coloured blue must must be connected to the terminal which is marked with the lettter
N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the lettter L or coloured red.
7
