FLOAT SHUT OFF
The cleaner is protected by an automatic shut-off float valve when it becomes full of liquid. This will
become apparent to you as the motor will start to make a high pitched noise. If this happens:
1) Switch the unit off.
2) Disconnect from the mains.
3) Lift the hose up to drain any excess liquid back into the container.
4) Empty the contents of the tank.
5) Try to keep the hose raised whilst emptying out the liquid, this can help eliminate any spills.
WARNING - BE CAREFUL WHEN EMPTYING THE TANK - IT MAY BE HEAVIER THAN YOU THINK.
Important
The float valve is a safety device, do not attempt to remove this or modify it, it is there for your safety.
Should the cleaner overturn during use, switch the unit off immediately, return to the upright position and
wait until the float valve has repositioned itself.
If collecting soapy water you will need to regularly check whether the unit requires emptying as the lather
can bypass the float system and there can be a discharge of foam! Should this occur switch off the unit,
wash out any foam in the filter and tip away any water around the outlet on the motor housing, before
restarting.
EMPTYING TANK
WARNING - TAKE CARE, THE TANK MAY BE HEAVIER THAN YOU THINK.
1) Switch off the unit and unplug from the socket.
2) Unclip the motor housing from the recovery tank.
3) Empty tank of all contents - making sure that you are protected against any sharp objects. Beware of
excess weight.
4) Clean filter.
5) Check and clean any blockages within the unit.
6) Replace motor housing, plug in and continue as before.
BLOWER FUNCTION
1) The CombiPowerVac
TM
can be used as a powerful blower by inserting the hose into the outlet on the
motor housing.
2) Always ensure that the hose, tank and accessories have been cleaned of any debris before operating
the blower function.
3) You should always protect your eyes with safety goggles when using this function and ensure that
no one else is in close proximity.
4) Uses include: blowing leaves into piles, blowing out dust from difficult to get to areas, faster drying of
paint.
Note - Always switch the unit off before changing between vacuum and blower functions.
FLOOR HEAD ASSEMBLY
To assemble the floor head, offer the brush/squeegee head up to the body and when securely in place,
clip the securing lock tabs into place with a firm finger pressure. To release, unclip by applying a firm fin-
ger pressure in an outwards direction. Do not under any circumstances use tools such as pliers or a
screwdriver as you may damage the product. If required, the brush/squeegee head can be cleaned with
warm soapy water.
5
