SAFETY OPERATING INSTRUCTIONS
2
PLEASE READ BEFORE USE
NEVER under any
circumstances aim the nozzle
at another person or animal. In the
event of injury occuring seek expert
medical advice immediately.
The spray gun must only be used
with paints and solvents that have a
suitable flash point for spraying. If in
doubt consult paint or solvent manu-
facturer’s data.
Always ensure there is adequate
ventilation when spraying.
NEVER spray near a naked flame,
including appliance pilot flame.
NEVER smoke whilst spraying.
NEVER allow children to operate or
play with the spray gun.
Always read the paint manufacturers
thinning instructions before using.
Always disconnect Combivac from
mains supply when refilling the paint
container.
Before cleaning, always disconnect
Combivac from the mains supply.
Always wear the correct protective
mask mask when spraying. We would
also recommend the use of gloves
and goggles.
After every use ensure that you clean
your spray gun thoroughly and
grease the packing piece.
WARNING: The substances used with
this spray gun (paint, thinner etc)
may contain hazardous, harmful,
explosive or corrosive materials.
ALWAYS COMPLY WITH THE SAFETY
INSTRUCTIONS ISSUED WITH THIS
PRODUCT AND THE MATERIAL
!
INTRODUCTION
HVLP stands for High Volume, Low Pressure. This is a type of spraying that
allows you to spray extremely accurately but without all the overspray that occurs
with the high pressure tank type equipment. In fact, in some parts of the world
the high pressure systems are banned by law on environmental grounds and
HVLP type systems are the only alternative for professional type spraying. This
gun is extremely easy to use, very safe and reduces the amount of paint used .
PLEASE NOTE
We have done all we can to ensure that used correctly and according to these
instructions, this spray gun will give long and trouble free life. We accept no
responsibility for damage caused by the use of incorrect or unsuitable
substances, paints or fluids which have not been thinned correctly or are
unsuitable for the surfaces to which they are applied, health hazards arising from
lack of ventilation when working in confined spaces or failure of the equipment
due to inadequate cleaning of the components after use.
If in doubt, always test a small inconspicuous area first. Always read the paint
manufacturer’s instructions first.
Neither our guarantee nor the above statement affects your statutory rights.
final.qxd 22/02/00 11:05 Page 2
