2
l
Keep work area clean - Cluttered areas and benches
invite injuries.
l
Consider work area environment - Do not expose the
spray gun to rain. Do not use the spray gun in damp
or wet locations. Keep work area well lit. Do not use
the spray gun where there is risk to cause fire or
explosion.
l
Guard against electric shock - Avoid body contact with
earthed or grounded surfaces (e.g. pipes, radiators,
ranges, refrigerators).
l
Keep children away - Do not let visitors touch the tool
or extension cord. All visitors should be kept away
from the work area.
l
Store idle tools - When not in use, tools should be
stored in a dry, high or locked place, out of reach of
children.
l
Do not force the tool - it will do the job better and
safer at the rate for which it was intended.
l
Dress properly - do not wear loose clothing or
jewellery, they can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended when
working outdoors. Wear protective hair covering to
contain long hair.
l
Always wear a mask when spraying.
l
We recommend the use of eye protection to keep
hazardous vapours out of eyes.
l
We recommend the use of ear protectors.
l
Do not abuse the cord - Never carry the tool by the
cord or yank it to disconnect it from the socket. Keep
the cord away from heat, oil and sharp edges.
l
Do not overreach - Keep proper footing and balance
at all times.
l
Always disconnect from mains supply when not in
use, when refilling the paint container and before
cleaning.
l
Avoid unintentional starting, do not carry a plugged in
tool with a finger on the switch and ensure the switch
is off when plugging in.
l
When tool is used outdoors, use extension cords only
intended for outdoor use.
l
It is recommended that a RCD (residual current
device) rated at 30mA is fitted into the mains supply
socket for added protection against electric shock.
l
Stay alert - Watch what you are doing. Use common
sense and do not operate tool when you are tired.
l
Never under any circumstances aim the nozzle at
another person or animal. In the event of injury
occuring seek expert medical advice immediately.
l
Always keep the spray basket nozzle in place during
use. Never allow the spray to come in direct contact
with the skin.
l
Always ensure there is adequate ventilation when
spraying.
l
Never spray near a source of ignition, e.g. hot
surfaces, sparks, cigarettes, glowing wires & open
flames including appliance pilot flame.
l
The spray gun must not be used for spraying
flammable materials below flashpoint 21˚C.
l
Always beware of any hazards presented by the
material being sprayed and consult the markings on
the container or the information supplied by the
manufacturer of the material to be sprayed, including
requirements for the use of personal protective
equipment. Do not spray any material where the
hazard is not known.
l
The spray gun must not be cleaned with flammable
liquids below flash point 21˚C.
l
Check for damaged parts - Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other
conditions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service centre
unless otherwise indicated in this instruction manual.
Have defective switches replaced by an authorized
service facility. Do not use the tool if the switch does
not turn it on and off.
l
Warning - The use of any accessory or attatchment,
other than those recommended in this instruction
manual, may present a risk of personal injury.
l
Maintain tools with care - Follow instructions for
lubrication and changing the accessories, inspect tool
regularly and if damaged, get repaired by an
authorized service centre.
l
Have your tool repaired by a qualified person - This
electric tool is in accordance with the relevant safety
requirements. Repairs should only be carried out by
qualified persons using original spare parts, otherwise
this may result in considerable danger to the user.
l
Use genuine Earlex parts only.
SAFETY OPERATING INSTRUCTIONS
WARNING: When using the spraygun, basic safety precautions, including
the following, should always be followed to reduce the risk of fire, electric
shock and personal injury.
Summary of Contents for AGS120
Page 10: ...10...
