![background image](http://html1.mh-extra.com/html/eandi/a-1000/a-1000_manual_3069764004.webp)
The material contained in this document is the property of Electronics & Innovation Ltd., it is
subject to change without notice.
September 2010
4
Revision A
Table 1-1. SPECIFICATIONS
FREQUENCY COVERAGE:
300 kHz to 35 MHz.
GAIN:
60 dB min, ±1.5 variation.
CLASS A LINEAR OUTPUT:
Nominal 1000 watts.
SATURATED RF POWER OUTPUT:
1500 Watts min
INPUT IMPEDANCE
50 ohms, VSWR, 1.5:1 Maximum.
OUTPUT IMPEDANCE:
50 ohms, VSWR, 2.5:1 Maximum
STs STABILITY:
Continuous operation into any load or
source impedance.
PROTECTION:
Unit will withstand a + 13 dBm input
signal (1.0 Volts RMS) for all output load
conditions, without damage.
POWER OUTPUT METER:
True RMS power detection. ±5% of full
scale accuracy.
POWER REQUIREMENTS:
3 208 VAC 47-63 Hz. 30 Amps
SIZE:
30 X 24 X 62 inches L x W X H
762 X 210 x 1575 mm. L x W x H
WEIGHT:
610 pounds 277 kg
CONNECTORS:
N
OPERATING TEMPERATURE:
0
– 30 C
RACK MOUNTING:
Chapter 2 Operation
2.1 INTRODUCTION
The A1000 RF amplifier is used to amplify the RF level of signal sources in the
300 KHz to 35 MHz range. No tuning or any other form of adjustment is required.
The A1000 produces rated power output at its output connector, regardless of
load impedance. Any power reflected due to output load mismatch is absorbed in
the amplifier. Therefore, although the output impedance is 50 ohms (maximum
VSWR: 2.5:1), the amplifier will work into any load impedance.